Name resolution? Can you ping by name and IP and have you tried connecting by IP?
On Mon, Aug 29, 2016, 8:58 AM Adam Juelich <[email protected]> wrote: > Ya, we are using the docking station. > > When it loads WinPE and I open up F8, I do have an IP address. > > On Mon, Aug 29, 2016 at 10:21 AM, Keith Garner (Hotmail) < > [email protected]> wrote: > >> If it can’t connect to the DeployRoot/Deployment share it would suggest >> to me that you don’t have the right network driver installed. Also I don’t >> think the Dell Venue 11 pro has a on-board nic, so you would either need to >> use the Docking Station or use a USB-NIC adapter. >> >> >> >> Standard Network troubleshooting applies here. Also: How to Debug >> missing Drivers in MDT Litetouch >> <https://social.technet.microsoft.com/Forums/en-US/3e083173-f5db-48e9-b744-f71b9ca6541c/how-to-debug-missing-drivers-in-mdt?forum=mdt> >> >> >> >> -k >> >> >> >> *From:* [email protected] [mailto: >> [email protected]] *On Behalf Of *Adam Juelich >> *Sent:* Monday, August 29, 2016 7:46 AM >> *To:* [email protected] >> *Subject:* [MDT-OSD] DeployRoot not found >> >> >> >> Hello Everyone, >> >> >> >> Let me preface this that I'm not a huge MDT guy. My OSD experience in >> the last 6 years has strictly been through ConfigMgr. I just started a new >> job and they have MDT 2012 in place and we are moving to ConfigMgr in a few >> months. I want to eventually utilize MDT more but I do not have a lot of >> time right now. I'd like to update their MDT instance and utilize the >> Windows 10 1607 ADK but since we will only be using it for a few >> more months I'm thinking about leaving well-enough alone... >> >> >> >> We are trying to image a Dell Venue 11 Pro with Windows 7......I know, >> doesn't make much sense but that is what is standardized right now. They >> have two boot images available, one is the LiteTouch and the other is one >> from the Windows 8 ADK. It boots to the Windows 8 one, runs the bootstrap >> settings, but then states that it cannot connect to the >> DeployRoot/DeploymentShare. If I do a 'pushd' to that UNC path after >> bringing up the Diagnostic Command Prompt, it cannot connect to it. >> >> >> >> I re-created the Task Sequence for that model as, initially, they were >> receiving an unattend error. >> >> >> >> On other models, the LiteTouch Boot Image works just fine and they should >> both be utilizing the same bootstrap.ini file. >> >> >> >> Any ideas? >> >> >> >> Thanks! >> > >
