Good Morning L-ers! one of our NPR report writers has written a rpt to print labels on a Genicom. He sends printer commands to setup the printer which works really well but when his report finishes printing, the NPR rpt sends additional printer commands (see below) that resets the printer which causes a problem when the users press the printer's formfeed.
Is there a way to prevent these printer commands from being sent? Here is the line of code that sets the printer back to 12 cpi 8 dpi and 66 lines. [4w [1;217s [1z [66t thank you everyone! Randy Poudre Valley Hospital Systems CONFIDENTIALITY NOTICE: The information contained in this e-mail is privileged and confidential, and is intended only for the use of the individual or entity named above. If you are not the intended recipient, you are notified that any disclosure, copying, distribution, electronic storage or use of this communication is prohibited. If you received this communication in error, please notify us immediately by e-mail, attaching the original message, and delete the original message from your computer and any network to which your computer is connected. =*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*= To subscribe or unsubscribe to the meditech-l, visit MTUsers.COM. To check the status of the meditech-l, visit MTUsers.NET. For help, email [EMAIL PROTECTED] ______________________________________ meditech-l mailing list [email protected] http://mtusers.com/mailman/listinfo/meditech-l
