We use the 2824 for wristbands and the 2844 for some PHA labeling. If the data is formatted correctly I can't say that I've seen them just stop printing part of the data. I've seen data not show up when it is formatted outside the edge of the label/wristband. During setup I had an issue with incorrect use of ZPL spacing codes that would eventually get the printer mis-configured so that it wouldn't print properly.
How are you sending data to the printer? I'd start by looking at the input to the printer to see if it is still specifying a barcode. Did the NPR/Optio/whatever that is feeding the printer change? ________________________________ From: [email protected] [mailto:[EMAIL PROTECTED] On Behalf Of Pearey, Tom Sent: Monday, January 08, 2007 4:51 PM To: [email protected] Subject: [MEDITECH-L] Zebra printer Is anyone using a Zebra LP2844 to print bar codes. We use the Zebra to print patient's wristbands and at one time it was printing patient info along with a barcode. The barcode suddenly stopped printing. Any info would be greatly appreciated. Tom Pearey-MIS Mgr. Pacific Alliance Med. Ctr. Ph# 213-437-4268 Fax 213-617-9203 [EMAIL PROTECTED]
=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*= To subscribe or unsubscribe to the meditech-l, visit MTUsers.COM. To check the status of the meditech-l, visit MTUsers.NET. For help, email [EMAIL PROTECTED] ______________________________________ meditech-l mailing list [email protected] http://mtusers.com/mailman/listinfo/meditech-l
