Errol,
Thanks heaps!!
Steve.
Errol Smith wrote:
> Steve,
> You can bolt up the head and manifolds. When you put the cam, in just back
> the crank off 90 degrees and the pistons will be well away from any valve
> being opened. Set the cam to the recommended lift @ TDC and bring the crank
> to TDC slowly feeling for any resistance. If resistance is felt check cam
> position again.
> Cheers
> Feral Errol
>
> ----------
> From: Steve Taylor <[EMAIL PROTECTED]>
> To: ozdat <[EMAIL PROTECTED]>
> Subject: Z18 rebuild
> Date: Wednesday, September 27, 2000 11:51
>
> Hey,
> Im rebuilding the z18et with a new head/cam setup after doing in the
> head gasket. Im still waiting on the cam so my question is can i bolt
> the head to the block and then when the cam comes in fit it up with the
> head on?? as in will the valves hit the pistons when im trying to do the
> cam timing??
> Cheers
> Steve.
>
--membersozdat-------------------------------------------------------
OZDAT Mailing List Please Note:-
Send (un)subscribe requests to [EMAIL PROTECTED]
Send submissions to [EMAIL PROTECTED]
No unauthorised redistribution of this email
http://www.ozdat.com/ozdatonline/index.htm
http://www.ozdat.com/ozdatonline/listindex.html
http://www.mail-archive.com/[email protected]/
---------------------------------------------------------------------
