Thanks Andrew Spot on info :) I was 3mm out with spacing of bolt holes
all fixed. Now all I have to do is get all these bends to locate the
turbo :)
Cheers Andrew
>
> Andrew,
> Have a look on this page.Is this what your after. Turbo picture page
> Andrew Smith
> Andrew Denniss wrote:
>
> Hi guys anyone have the dimensions for the flange on a T25
> turbo I have
> only measured roughly it came up as 90x65 plate with 4x 12mm
> holes 75mm
> spacing and 40mm spacing can some one check if thats right
> as its still
> on car and hard to measure. I sold my old turbo to pete
> libig .So I cant
> measure my old one. Im about 30% done on my turbo
> extractors.
> Thanks Andrew
>
> --membersozdat-------------------------------------------------------
>
> OZDAT Mailing List Please Note:-
> Send (un)subscribe requests to [EMAIL PROTECTED]
>
> Send submissions to [EMAIL PROTECTED]
> No unauthorised redistribution of this email
> http://www.ozdat.com/ozdatonline/index.htm
> http://www.ozdat.com/ozdatonline/listindex.html
> http://www.mail-archive.com/[email protected]/
> ---------------------------------------------------------------------
>
> --membersozdat-------------------------------------------------------
> OZDAT Mailing List Please Note:-
> Send (un)subscribe requests to [EMAIL PROTECTED]
> Send submissions to [EMAIL PROTECTED]
> No unauthorised redistribution of this email
> http://www.ozdat.com/ozdatonline/index.htm
> http://www.ozdat.com/ozdatonline/listindex.html
> http://www.mail-archive.com/[email protected]/
> ---------------------------------------------------------------------
--membersozdat-------------------------------------------------------
OZDAT Mailing List Please Note:-
Send (un)subscribe requests to [EMAIL PROTECTED]
Send submissions to [EMAIL PROTECTED]
No unauthorised redistribution of this email
http://www.ozdat.com/ozdatonline/index.htm
http://www.ozdat.com/ozdatonline/listindex.html
http://www.mail-archive.com/[email protected]/
---------------------------------------------------------------------
