Thanks foir the measurements :)Extractors are about 20-30% done. Good to
hear the turbo is going well. Once I get my good computer going Ill send
you my new number as Im living with inlaws at moment while we build the
new house ect. Just bought 1 acre block last week and fitted new beefy
front end to the datsun with 275lb 3"springs adjustable platforms and
revalved custom inserts :)
Talk to you soon Andrew
>
> Andrew,
>
> Flange specs are as follows:
>
> Holes - 9mm
> Hole spacing - 73x40
> Outer flange dims - 91x65
> Hole in middle - 49x37.5, 12mm rads in corners
>
> PL
>
> PS: I'll call you about the new turbo - it's on and going. Very happy. Even
> better response than the std. turbo, but with more top end. I can't test the
> top end properly though because now my clutch is now slipping...
>
> -----Original Message-----
> From: [EMAIL PROTECTED]
> [mailto:[EMAIL PROTECTED]] On Behalf Of Andrew Denniss
> Sent: Thursday, 7 December 2000 19:40
> To: [EMAIL PROTECTED]
> Subject: GarretT25 flange spacing
>
> Hi guys anyone have the dimensions for the flange on a T25 turbo I have
> only measured roughly it came up as 90x65 plate with 4x 12mm holes 75mm
> spacing and 40mm spacing can some one check if thats right as its still
> on car and hard to measure. I sold my old turbo to pete libig .So I cant
> measure my old one. Im about 30% done on my turbo extractors.
> Thanks Andrew
>
--membersozdat-------------------------------------------------------
OZDAT Mailing List Please Note:-
Send (un)subscribe requests to [EMAIL PROTECTED]
Send submissions to [EMAIL PROTECTED]
No unauthorised redistribution of this email
http://www.ozdat.com/ozdatonline/index.htm
http://www.ozdat.com/ozdatonline/listindex.html
http://www.mail-archive.com/[email protected]/
---------------------------------------------------------------------
