Craig,
I just carefully grind away the weld using an angle grinder. when you get close
to the mark you start to see the join, then tap them out with a hamer turn them
around and weld them back in.
Andrew Smith
Craig Harris wrote:
> Hello ozdators,
>
> Has anyone reversed the sleeves on a 510 front x member? Just wandering what
> you used to cut them and keep them level when rewelding. I was going to use
> a hole saw and hollow tube inserted into the sleeve as a guide so that the
> cutter didnt bounce around too much.
>
> Any ideas?
>
> Craig
>
> _________________________________________________________________________
> Get Your Private, Free E-mail from MSN Hotmail at http://www.hotmail.com.
>
--membersozdat-------------------------------------------------------
OZDAT Mailing List Please Note:-
Send (un)subscribe requests to [EMAIL PROTECTED]
Send submissions to [EMAIL PROTECTED]
No unauthorised redistribution of this email
http://www.ozdat.com/ozdatonline/index.htm
http://www.ozdat.com/ozdatonline/listindex.html
http://www.mail-archive.com/[email protected]/
---------------------------------------------------------------------
