Craig,
I did mine the same way as Andrew. It took about 20 minutes and was no
problem. The end result looks pretty neat.
Eddie
England
1969 510 4door
[EMAIL PROTECTED]
www.ratdat.com
> I just carefully grind away the weld using an angle grinder. when you get
close
> to the mark you start to see the join, then tap them out with a hamer turn
them
> around and weld them back in.
> Andrew Smith
>
> Craig Harris wrote:
>
> > Hello ozdators,
> >
> > Has anyone reversed the sleeves on a 510 front x member? Just wandering
what
> > you used to cut them and keep them level when rewelding. I was going to
use
> > a hole saw and hollow tube inserted into the sleeve as a guide so that
the
> > cutter didnt bounce around too much.
> >
> > Any ideas?
> >
> > Craig
> >
> >
_________________________________________________________________________
> > Get Your Private, Free E-mail from MSN Hotmail at
http://www.hotmail.com.
> >
>
>
--membersozdat-------------------------------------------------------
OZDAT Mailing List Please Note:-
Send (un)subscribe requests to [EMAIL PROTECTED]
Send submissions to [EMAIL PROTECTED]
No unauthorised redistribution of this email
http://www.ozdat.com/ozdatonline/index.htm
http://www.ozdat.com/ozdatonline/listindex.html
http://www.mail-archive.com/[email protected]/
---------------------------------------------------------------------
