Tom,
Yes it will be on LPG. I think that LPG is still a good fuel to use due to
its octane rating and cost. More bang for your buck!
I am looking at using a Z electronic dissy as well as a trial. The dissy
will be modified to fire both sets of plugs simultaneously and use two ET
pulsar coils and Darlington transistors to provided the sparks. Anthony
Morrow runs this ignition setup very successfully on his Z18ET "NIZPRO" 510
race car (420hp).
Cheers
Feral Errol
mailto:[EMAIL PROTECTED]
http://www.datrats.com.au/
-----Original Message-----
From: [EMAIL PROTECTED]
[mailto:[EMAIL PROTECTED]]On Behalf Of Tom Richardson
Sent: Tuesday, February 06, 2001 11:51 PM
To: [EMAIL PROTECTED]
Subject: RE: z18et wiring...
hands off, that manifold and turbo are going on my z20e when errol is bored
with it hehe :)
still running it on lpg errol? I think this would be the way to go- spend
the 1500 on lpg rather than an ecu, plus cheap fuel and higher octane, win
win win! all the EFI hose I jus put into my 510 at $25/m will be redundant
though... bugger ;)
-----Original Message-----
From: [EMAIL PROTECTED]
[mailto:[EMAIL PROTECTED]]On Behalf Of Daniel Kroehn
Sent: Tuesday, 6 February 2001 10:30 PM
To: [EMAIL PROTECTED]
Subject: Re: z18et wiring...
That will be one interesting motor mate, let us know how it turns out, I
might have to rethink my Z-18et project ;) . Hey what computer are you
using. Is it a standard Z-18et or Z20e or maybe an aftermarket job?
Daniel Kroehn
Recommending Datrats, supplying quality Datsun performance parts
www.Datrats.com.au
----- Original Message -----
From: R.Hunter <[EMAIL PROTECTED]>
To: <[EMAIL PROTECTED]>
Sent: Friday, February 25, 2000 12:43 PM
Subject: z18et wiring...
> I'm currently trying to put z18t frankenstein motor in my 1200 coupe and
> have a question about the a little speed sensor thing in the speedo. It's
a
> complete original S-110 gazelle loom and speedo unit and i'm using the
> complete s-110 loom but mating it to the 1200 old instruments...but I need
> to know whether the sensor in the speedo is for the computer or just for a
> 100kmh bell / chime. Can I leave it disconected if it is for comp.? or
will
> it stuff idle mixtures or idle speed? I remember something about Fj20t
> using a speed sensor and rb30 but what about Z18t?
> Thanks for any help.
> Rhys hunter.
>
> .....also I'm using 2" od tubing to a front mount vr4 mitsi intercooler
and
> 2-1/4"
> to the throttle body...(motor is z20e block,l20b crank,z20 pistons,z18et
> head,86mm bore.) will this size tubing be sufficient to make good
> horsepower without overkill?
>
--membersozdat-------------------------------------------------------
OZDAT Mailing List Please Note:-
Send (un)subscribe requests to [EMAIL PROTECTED]
Send submissions to [EMAIL PROTECTED]
No unauthorised redistribution of this email
http://www.ozdat.com/ozdatonline/index.htm
http://www.ozdat.com/ozdatonline/listindex.html
http://www.mail-archive.com/[email protected]/
---------------------------------------------------------------------
