FJ Man why not fit a Silvia or pulsar radiator you will find they are the
correct height and the outlets are in the correct place depending on which
engine you use
-----Original Message-----
From: Andrew Denniss <[EMAIL PROTECTED]>
To: [EMAIL PROTECTED] <[EMAIL PROTECTED]>
Date: Monday, March 26, 2001 1:45 AM
Subject: Re: attn: andrew dennis
>Hi chris the VN V8 rad fitted with few mods it was perfect in width as it
>just fitted between the rails It is a little high but still clears the
>bonnet. I have made little alloy brackets to keep it in place up top the
>bottom just has the standard rubber with a peg that locates on the two
holes
>I drilled in the rails.I fitted new tanks to mine as I wanted it to be a
>single pass not duel pass radiator plus the inlet had to be changed from
>drivers side top to passenger side top.Hope this helps unsure how you would
>go in a 1600. I didnt have to chop any of my original rad support out only
>for the intercooler plumbing
>cheers Andrew
>
>FJ MAN wrote:
>
>> what mods did you have to do to fit a vn v8 radiator
>> id like to fit one but all measurements seem to suggest no way so im
>> guessing theres more room in the 1200 bay or mods were made i see its
>> slightly above the radiator support panel yet on a 1600 its a good few
>> centrimetres over
>> ah well any advise is appreciated :)
>> regards chris
>> _________________________________________________________________________
>> Get Your Private, Free E-mail from MSN Hotmail at http://www.hotmail.com.
>>
>
--membersozdat-------------------------------------------------------
OZDAT Mailing List Please Note:-
Send (un)subscribe requests to [EMAIL PROTECTED]
Send submissions to [EMAIL PROTECTED]
No unauthorised redistribution of this email
http://www.ozdat.com/ozdatonline/index.htm
http://www.ozdat.com/ozdatonline/listindex.html
http://www.mail-archive.com/[email protected]/
---------------------------------------------------------------------
