I believe you must get the front flange from a local r200, and then your 1600 tailshaft will bolt to that. What are you doing about the 1/2 shafts? does it have CV joints? All, I got my R200 last night!! It was origanally out of a Jap R31 skyline. It is a 4.4 LSD. It cost me $350. The tail shaft flange bolt pattern is larger than my 1600 tailshft. I tried putting a input shaft from a R160 in the R200, but alas, it did'nt work. Do I:- (a) Cut the uni-joint from the old tail-shaft and get it welded and balanced onto my 1600 tail-shaft??? where would be a good place to get this done in ACT??? What price am I looking at???? (b) source a tailshaft from another Nissan/Datsun that has the larger flange and will bolt to my R200 and fit the gearbox at the other end??? (My 1600 tail-shaft is original 1600 length). Does such a tail-shaft exist??? (c) Drill holes into the R200 input flange so it can accomadate my 1600 stock tail-shaft???? thanks for your help Damien. _________________________________________________________________________ Get Your Private, Free E-mail from MSN Hotmail at http://www.hotmail.com. ____________________________________________________________________ Get free email and a permanent address at http://www.netaddress.com/?N=1 --membersozdat------------------------------------------------------- OZDAT Mailing List Please Note:- Send (un)subscribe requests to [EMAIL PROTECTED] Send submissions to [EMAIL PROTECTED] No unauthorised redistribution of this email http://www.ozdat.com/ozdatonline/index.htm http://www.ozdat.com/ozdatonline/listindex.html http://www.mail-archive.com/[email protected]/ ---------------------------------------------------------------------
