Iggy,
The tailshaft yoke is nothing special for the FJ 71B gearbox, any RWD Datto
tailshaft has the same yoke but some of the 4 cylinder shafts will require
the dust cover to be removed (eg a 1600 shaft). Unless the surface where the
seal contacts is completely stuff the rusty one should be OK as it is case
hardened and I doubt a little surface rust has done anything bad other than
look crap. To clean it up, use some very fine wet & dry with a bit of liquid
dishwashing detergent and wash it off with water - should come up good as
new, then apply some light machine oil to keep looking good and shove it
under you house instead of outside in the elements.
regards
Terry
-----Original Message-----
From: [EMAIL PROTECTED]
[mailto:[EMAIL PROTECTED]]On Behalf Of
[EMAIL PROTECTED]
Sent: Wednesday, 2 May 2001 6:18
To: [EMAIL PROTECTED]
Subject: Tailshaft yoke.
Guys,
Does anyone know where one can get a new yoke for a tailshaft for the FJ20
gearbox??
The one I have has rusted itself silly from sitting around (my fault I know)
or does anyone know how to clean it up maybe?
Iggy Sandejas
Sydney NSW
Datsun 1600 FJ20t
--membersozdat-------------------------------------------------------
OZDAT Mailing List Please Note:-
Send (un)subscribe requests to [EMAIL PROTECTED]
Send submissions to [EMAIL PROTECTED]
No unauthorised redistribution of this email
http://www.ozdat.com/ozdatonline/index.htm
http://www.ozdat.com/ozdatonline/listindex.html
http://www.mail-archive.com/[email protected]/
---------------------------------------------------------------------
