dont you just have to swap your rubber mounting (between x/member and g/box)
over to the new box and use the stock g/box xmember.
i have one of these on the back of a Z18ET, only problem being the slight
angle it sits on. its all good.
ryan
----- Original Message -----
From: "David Thompson" <[EMAIL PROTECTED]>
To: <[EMAIL PROTECTED]>
Sent: Monday, June 04, 2001 11:15 PM
Subject: Re: [Stumpy skyline 5spd]
> You should have to do NO mods at all for a 1600/510. I have this box in my
> 1600, and since it is the same length as the original box, no tailshaft or
> gearbox crossmember mods were needed.
>
> Michael Cassidy <[EMAIL PROTECTED]> wrote:
> Can someone tell me the easies way to mod the g/box xmember for a
> stumpy skyline 5spd? i seem to remember the x-member had to be spaced
> about 20mm but do i need to reverse the xmember or slot the g/box to
> mount bolt holes??
>
> thanx
>
> Michael
>
>
> ____________________________________________________________________
> Get free email and a permanent address at http://www.netaddress.com/?N=1
>
--membersozdat-------------------------------------------------------
OZDAT Mailing List Please Note:-
Send (un)subscribe requests to [EMAIL PROTECTED]
Send submissions to [EMAIL PROTECTED]
No unauthorised redistribution of this email
http://www.ozdat.com/ozdatonline/index.htm
http://www.ozdat.com/ozdatonline/listindex.html
http://www.mail-archive.com/[email protected]/
---------------------------------------------------------------------
