Re: Flywheel Machining

[andrew smith]

Daniel, The flywheel from the L18w motor in the 720 utes have a lighter flywheel and also have a 225mm clutch. Andrew Smith Daniel Kroehn wrote: List,I'm looking at getting my stock z-18et flywheel lightened a little to make the engine a bit more responsive.  Anyway, after studying the archives I see that I should take material from the outside of the flywheel which makes perfect sense.  I noticed I can only take a few mm from the outside so the pressure plate will still bolt on but I'm unsure where the dowels for the ring gear are located?  Is there anyway I could get the flywheel and ring gear apart or is that something the machinist will have to do?  My only other question is should I also get a little taken of one of the faces of the flywheel as well or just stick to get a few mm taken from the outside?Thanks heaps in advance. Daniel KroehnRecommending Datrats, supplyin quality Datsun performance partswww.Datrats.com.au  --membersozdat------------------------------------------------------- OZDAT Mailing List Please Note:- Send (un)subscribe requests to [EMAIL PROTECTED] Send submissions to [EMAIL PROTECTED] No unauthorised redistribution of this email http://www.ozdat.com/ozdatonline/index.htm http://www.ozdat.com/ozdatonline/listindex.html http://www.mail-archive.com/membersozdat@datascribe.com.au/ --------------------------------------------------------------------- --membersozdat------------------------------------------------------- OZDAT Mailing List Please Note:- Send (un)subscribe requests to [EMAIL PROTECTED] Send submissions to [EMAIL PROTECTED] No unauthorised redistribution of this email http://www.ozdat.com/ozdatonline/index.htm http://www.ozdat.com/ozdatonline/listindex.html http://www.mail-archive.com/membersozdat@datascribe.com.au/ ---------------------------------------------------------------------