yeah I originally had the charge light connected to the yellow wire that
comes off the alternator. It is a bullet-type connector. No charge then. But
I think it is charging now, I'll have to see how it is going over the next
week or so.

zac

----- Original Message -----
From: Terry Rudd <[EMAIL PROTECTED]>
To: <[EMAIL PROTECTED]>
Sent: Thursday, October 18, 2001 10:18 PM
Subject: RE: Bosch alternator wiring


> D+ on the Alternator is the correct terminal for the charge light. The D+
> wire does have to be connected for the reg to operate correctly - A Bosch
> will charge without this wire but it's output is erratic (amps wise) and
> also the voltage fluctuates. I cant see how you wired it incorrectly
though
> unless you didn't connect the D+ to the white/red wire on the loom.
> I new that Hitachi wouldn't fire without the charge circuit connected but
> there was a few posts on the topic last week so I test my Bosch and found
it
> to be dodgy without the light connected - very interesting.
>
> regards
> Terry
>
> -----Original Message-----
> From: [EMAIL PROTECTED]
> [mailto:[EMAIL PROTECTED]]On Behalf Of Zac Campbell
> Sent: Thursday, 18 October 2001 10:16 PM
> To: [EMAIL PROTECTED]
> Subject: Re: Bosch alternator wiring
>
>
> Thanks Terry
> Well it kicked over fine today - just yesterday it struggled to turn it
> against the compression but could still start the engine.
> I had it connected like that before and the charge light was on. turned
out
> it was not charging. then I took it out and the guy that tested it told me
I
> had had it wired incorrectly. He said the charge light needed to be
> connected to make the alternator charge (somehow). I then connected the
> charge light (white/red) to one of the spade terminals on the alt (think
> this was D+). now the charge light isn't on but perhaps the alternator is
> just worn out (as per slightly glowing CHG at night).
>
> cheers,
> zac
>
> ----- Original Message -----
> From: Terry Rudd <[EMAIL PROTECTED]>
> To: <[EMAIL PROTECTED]>
> Sent: Thursday, October 18, 2001 9:02 PM
> Subject: RE: Bosch alternator wiring
>
>
> > Zac,
> >
> > It's unlikely that your wiring is wrong on a Bosch alternator, they are
so
> > simple to hook up.
> >
> > The Bat wire is the thick White one
> > The Ind wire is the small Yellow one
> > The Earth is Black
> >
> > make sure the Hitachi voltage reg plug is disconnected (usually near
stock
> > battery position on the tower) and you splice the Ind wire (yellow) from
> the
> > alternator into the loom at the old reg plug (White/Red trace) and
that's
> it
> > done. Check the "common" fuse in the box and check the connection in the
> big
> > white wire going into the fuse box and check the connection of the white
> > wire at the starter motor. Check the engine earth is secure and also the
> > body earth that near where the Hitachi reg was bolted on to the strut
> tower.
> > Ind light glowing under load usually tells me the voltage reg is stuffed
> or
> > the brushes are arcing under load.
> >
> >  To check visually if your alternator is charging without any meters,
> start
> > the engine and turn on your headlights, rev the engine up to 2K rpm and
> the
> > light shout go bright and then return to idle and the lights should dim
> > slightly.
> >
> > regards
> > Terry
> >
> > -----Original Message-----
> > From: [EMAIL PROTECTED]
> > [mailto:[EMAIL PROTECTED]]On Behalf Of
> > [EMAIL PROTECTED]
> > Sent: Thursday, 18 October 2001 9:30 AM
> > To: [EMAIL PROTECTED]
> > Subject: Bosch alternator wiring
> >
> >
> > Hi guys, I seem to be experiencing problems with my Bosch alternator. I
> have
> > had it out and tested, it made over 13v easily but amps was a little
high
> > (not
> > sure what that means, the tester just commented on it).
> > I am thinking perhaps the wiring is wrong?
> > Can someone go through the wiring method again with me?
> > Are there some other wires on the loom that I need to plug/remove?
> > Unfortunately the loom is not original, I replaced it with one from an
> auto
> > vehicle. Not sure what year though.
> >
> > thanks,
> > zac
> >
> >
>
>
>

--membersozdat-------------------------------------------------------
OZDAT Mailing List   Please Note:-
Send (un)subscribe requests to  [EMAIL PROTECTED]
Send  submissions to  [EMAIL PROTECTED]
No unauthorised redistribution of this email
http://www.ozdat.com/ozdatonline/index.htm
http://www.ozdat.com/ozdatonline/listindex.html
http://www.mail-archive.com/[email protected]/
---------------------------------------------------------------------

Reply via email to