----- Original Message -----
Sent: Thursday, January 10, 2002 11:06
PM
Subject: Re: member
when i put the 5speed in my 1600, i
had to modify the crossmember. i cut the bit out where the gearbox mount goes,
then bolted up the other two halves to the body.
then i bolted the middle bit up to the box,
with a jack underneath it, put it up to the right height, then cut out
some 3mm mild steel plate to make it all fit together,
tack welded it all together , while it was still on the car , took
it of then fully welded it.
mark k
----- Original Message -----
Sent: Thursday, January 10, 2002 9:48
PM
Subject: member
Guys
I have a small
problem with my gearbox cross member. It does not fit.
I am not sure
what will fit and don't know any decent datto blokes in the north ACT area
keen to give me a hand.
Would it be
possible to get a metal fabricator/merchant to make one for
me?
would it cost
much?
what should he
made it out of? mild steel?
cheers for
those who
answer
--membersozdat-------------------------------------------------------
OZDAT Mailing List Please Note:-
Send (un)subscribe requests to
[EMAIL PROTECTED]
Send submissions to
[EMAIL PROTECTED]
No unauthorised redistribution of this
email
http://www.ozdat.com/ozdatonline/index.htm
http://www.ozdat.com/ozdatonline/listindex.html
http://www.mail-archive.com/[email protected]/
---------------------------------------------------------------------
--membersozdat-------------------------------------------------------
OZDAT Mailing List Please Note:-
Send (un)subscribe requests to
[EMAIL PROTECTED]
Send submissions to
[EMAIL PROTECTED]
No unauthorised redistribution of this
email
http://www.ozdat.com/ozdatonline/index.htm
http://www.ozdat.com/ozdatonline/listindex.html
http://www.mail-archive.com/[email protected]/
---------------------------------------------------------------------
