Iggy, The heater water comes out of the block between cyls 3/4 under the inlet mani, goes thru the heater and then is sucked through the hose that goes parallel to the block (also under the inlet mani) and also note the rubber hose connects to a metal runner hose that continues up the front of the engine, then it takes a turn across the front above the pulleys and then there is another rubber flexi fitting that connects into the lower radiator inlet into the water pump.
Most heaters are such thru so you look for the fitting on the water pump near where the lower radiator hose connects. regards, Terry -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]]On Behalf Of Sandejas, Ignacio Sent: Tuesday, 15 January 2002 11:51 AM To: '[EMAIL PROTECTED]' Subject: RE: FJ20 Help Pls. I as going to ask a similar question: Wondering if anyone knew which way the coolant flows through the FJ block to the heater. Does it come out the front fitting and back into the rear? -----Original Message----- From: Swann, James [mailto:[EMAIL PROTECTED]] Sent: Tuesday, January 15, 2002 9:48 AM To: '[EMAIL PROTECTED]' Subject: FJ20 Help Pls. G'Day all, I've noticed on my FJ20T that their is a pipe between intake ports 3 and 4 which appears to be either a water inlet or outlet for the head. Can someone pls tell me the correct way to set this up. I'm presuming it's Teed off one of the heater pipes and should I be hooking this into the raditator outlet (bottom pipe) or return (top pipe). Can't wait to try and turn this puppy over and see what happens!!!!! Thank for your help. Swanny. --membersozdat------------------------------------------------------- OZDAT Mailing List Please Note:- Send (un)subscribe requests to [EMAIL PROTECTED] Send submissions to [EMAIL PROTECTED] No unauthorised redistribution of this email http://www.ozdat.com/ozdatonline/index.htm http://www.ozdat.com/ozdatonline/listindex.html http://www.mail-archive.com/[email protected]/ ---------------------------------------------------------------------
