The easiest way to get an L20 to sit under the bonnet is to cut the LH engine mount metal bracket vertically, then reweld it so the LH engine side is slightly lower, 5mm offset is more than enough. After grinding the welding flush and repainting black nobody will detect this modification under the manifolding. Alternatively use a side draft carby set up. ----- Original Message ----- From: "Leighton" <[EMAIL PROTECTED]> To: <[EMAIL PROTECTED]> Sent: Thursday, 28 February 2002 15:15 PM Subject: Re: 1600 rubber engine mounts????
> i need these for a L20B into a 1600 - does those mounts let the motor sit > low enough so the bonett clear the engine??? > > thanx > > Leighton > ----- Original Message ----- > From: "Andrew Greenbury" <[EMAIL PROTECTED]> > To: <[EMAIL PROTECTED]> > Sent: Thursday, February 28, 2002 2:58 PM > Subject: Re: 1600 rubber engine mounts???? > > > > Hi Leighton, > > > > Cant you use some from a 180b or 200b or B'bird, therefore get > > some at the wreckers? > > > > Andrew > > > > > does anyone have any or know where i can get some??? > > > > > > > > > ta > > > > > > Leighton > > > > > > > > > > > --membersozdat------------------------------------------------------- OZDAT Mailing List Please Note:- Send (un)subscribe requests to [EMAIL PROTECTED] Send submissions to [EMAIL PROTECTED] No unauthorised redistribution of this email http://www.ozdat.com/ozdatonline/index.htm http://www.ozdat.com/ozdatonline/listindex.html http://www.mail-archive.com/[email protected]/ ---------------------------------------------------------------------
