I just put a 3.5inch hole through my crossmember. The 3 inch exhaust fits through no probs at all and I didn't have to cut the box section all the way to the edge.
Cheers Daniel Kroehn ----- Original Message ----- From: "Adam Jackson" <[EMAIL PROTECTED]> To: <[EMAIL PROTECTED]> Sent: Tuesday, August 13, 2002 8:03 AM Subject: Re: 1600 slotted rear crossmember? > Should the rear X member be seam welded? I can see why it is done, but could > you get away with it not being done? > > ----- Original Message ----- > From: [EMAIL PROTECTED] > To: [EMAIL PROTECTED] > Sent: Tuesday, August 13, 2002 3:52 AM > Subject: Re: 1600 slotted rear crossmember? > > > My only recommendation would be to have your xmember (if you modify it > yourself) exhaust hole enlarged, take it to an engineer and have them plasma > cut the hole to 4" rather than use a hole saw, as a large daim. capable of > cutting through will be more expensive and time consuming. > > > > > > > > Do You Yahoo!? > HotJobs, a Yahoo! service - Search Thousands of New Jobs > --membersozdat------------------------------------------------------- > OZDAT Mailing List Please Note:- > Send (un)subscribe requests to [EMAIL PROTECTED] > Send submissions to [EMAIL PROTECTED] > No unauthorised redistribution of this email > http://www.ozdat.com/ozdatonline/index.htm > http://www.ozdat.com/ozdatonline/listindex.html > http://www.mail-archive.com/[email protected]/ > --------------------------------------------------------------------- > --membersozdat------------------------------------------------------- OZDAT Mailing List Please Note:- Send (un)subscribe requests to [EMAIL PROTECTED] Send submissions to [EMAIL PROTECTED] No unauthorised redistribution of this email http://www.ozdat.com/ozdatonline/index.htm http://www.ozdat.com/ozdatonline/listindex.html http://www.mail-archive.com/[email protected]/ ---------------------------------------------------------------------
