Thanx, its back, and it looks good, cant wait till the morning when I can see it properly. I'll post some pictures soon, and be on some cruises :) ----- Original Message ----- From: "Richard Clough" <[EMAIL PROTECTED]> To: <[EMAIL PROTECTED]> Sent: Tuesday, August 20, 2002 10:07 PM Subject: Re: door rubber
> The Boot has a different profile rubber seal. Think about putting a rubber > seal on the boot lid, rather than in the body channel, about 20mm further > out than the traditional channel mounted seal. This keeps the seal out of > the channel and stops dirt, and later rust, under starting the rubber. My > son did this mod a few years ago. It seals perfectly, and no rust growth in > the channel. > ----- Original Message ----- > From: "Richard Webb" <[EMAIL PROTECTED]> > To: <[EMAIL PROTECTED]> > Sent: Sunday, 18 August 2002 21:44 PM > Subject: Re: door rubber > > > > Thanks Andrew and Richard... > > > > My 1600 is off at the spray painters at the moment and is due back on > > wednesday! so I was hoping to get the rubbers and stuff before it came > back. > > > > Its about $50 a door or 9.21 a metre so I guess if I get 15 metres it > should > > be enough.... the boot isnt the same rubber is it? > > > > Richard > > ----- Original Message ----- > > From: "GREENBURY, Andrew Robert" <[EMAIL PROTECTED]> > > To: <[EMAIL PROTECTED]> > > Sent: Sunday, August 18, 2002 8:26 PM > > Subject: Re: door rubber > > > > > > > Hi Richard, > > > > > > By my measurements, front door seals are 3.4m ea, rear door seals 3.3m > ea, > > > front door bailey channel 2.2m ea, rear door bailey channel 2.01m ea. > > > > > > Total 13.4m door seal; 8.42m bailey channel > > > > > > Id check the measurements, and buy a bit extra to be sure. > > > > > > Andrew > > > > > > On Sun, 18 Aug 2002, Richard Clough wrote: > > > > > > > Cant help with the door lengths. You will have to measure them or you > > > > can buy made up sets for about $40 each. You are correct on bailey > > > > channel, it is the channel the windows run in. Make sure you get the > > > > right size to fit Datsun channels. > > > > > > > ----- Original Message ----- > > > > From: Richard Webb > > > > To: [EMAIL PROTECTED] > > > > Sent: Sunday, 18 August 2002 18:02 PM > > > > Subject: door rubber > > > > > > > > > > > > > > > Does anyone know the length or rubber required for 4 doors of a > 1600? > > > > > > > > Also can someone please tell me what a baileys channel is? is that > the > > > > felt/rubber bit which your windows slide down? > > > > > > > > --membersozdat------------------------------------------------------- OZDAT Mailing List Please Note:- Send (un)subscribe requests to [EMAIL PROTECTED] Send submissions to [EMAIL PROTECTED] No unauthorised redistribution of this email http://www.ozdat.com/ozdatonline/index.htm http://www.ozdat.com/ozdatonline/listindex.html http://www.mail-archive.com/[email protected]/ ---------------------------------------------------------------------
