Where did you get that one from? The only place I could find them was
gasweld, and they wouldn't sell them individually, you had to buy a
whole set. It did feel a little dodgy using a cut up allen key, but I
kept it as net fitting as possible, and it ended up working ok.

Tuesday, November 05, 2002, 8:28:24 PM, you wrote:

RW> Richard.
RW> I think it is a 10mm allen key, I would not use a allen key though, as you need 
the proper tool to get they head torque right.
RW> I think the one I bought was under $10.00.
RW> The proper tool is a one piece socket with a hex head coming out of the end.
RW> Later.
RW> Rick White.
RW> P.S Make sure you get atleast 1/2 inch drive though.
RW>   ----- Original Message ----- 
RW>   From: Richard Webb 
RW>   To: [EMAIL PROTECTED] 
RW>   Sent: Wednesday, November 06, 2002 10:09 AM
RW>   Subject: L20b head bolts


RW>   Can someone tell me if I need some special tool to remove the head bolts. They 
look kinda like an alien key or something. Im sure when I was working on my A series 
engine they were just a
RW> standard 12 or 14.

RW>   Im planning to put a new cam in the head and do some work on it, is there 
anything I need to do like keep it TDC or anything? It will be going on my other L20b 
engine so I dont need to worry
RW> about the timing chain or anything.

RW>   Richard

RW>   --membersozdat------------------------------------------------------- 
RW>   OZDAT Mailing List Please Note:- 
RW>   Send (un)subscribe requests to [EMAIL PROTECTED] 
RW>   Send submissions to [EMAIL PROTECTED] 
RW>   No unauthorised redistribution of this email 
RW>   http://www.ozdat.com/ozdatonline/index.htm 
RW>   http://www.ozdat.com/ozdatonline/listindex.html 
RW>   http://www.mail-archive.com/membersozdat@;datascribe.com.au/ 
RW>   ---------------------------------------------------------------------




-- 
Best regards,
 Bob                            mailto:rcs07@;uow.edu.au

--membersozdat-------------------------------------------------------
OZDAT Mailing List   Please Note:-
Send (un)subscribe requests to  [EMAIL PROTECTED]
Send  submissions to  [EMAIL PROTECTED]
No unauthorised redistribution of this email
http://www.ozdat.com/ozdatonline/index.htm
http://www.ozdat.com/ozdatonline/listindex.html
http://www.mail-archive.com/membersozdat@;datascribe.com.au/
---------------------------------------------------------------------

Reply via email to