where are you fj man ??? i would be interested in the Gearbox and cross member and tail shaft???
thanx Leighton ----- Original Message ----- From: "FJ MAN" <[EMAIL PROTECTED]> To: <[EMAIL PROTECTED]> Sent: Friday, November 15, 2002 9:00 PM Subject: lots of parts for sale > > > Time to get rid of some less needed partsl > Intercooler , used for one week (can inspect) custom made core size = > 550x400x67 tube and fin, overall width 750mm 2.5inch outlets, very good > quality weldin, made up by rotormotion in perth usin kj thermal core. lookin > for around $550. > > Z18/20 motor rebuilt, with cam,head work, xf falcon throttle body, ca18det > injectors, fj20 CAS so it runs just 4 plugs not the original 8, all built by > previous owner, very strong motor. custom sump and mounts for slottin > straight into a 1600. Does not come with turbo only. (offers of a reasonable > nature) > > Mtx8 microtech to suit z18/20 motor runnin CAS, with or without loom, comes > with coil packs and 4 line handset, used on car for a week before ripped > down for rebuild. Is tuned to run motor with ca18det injectors (dyno > tunin/maps on computer alone cost 6 hours dyno time.) obviously useless if > not used on motor but a good buy for a datto owner. lookin for $750 with > handset and coils. > > brand new never used clutch from direct clutches in brisbane ... rated at > 700hp, 4 puck, sprung centre. cost 700 dollars to suit z18/20 motor, but it > should suit fj20 turbo motors too depends on flywheel. its brand new lookin > at least 450 for it, (inspection will show its never been used). > > Fuel supply set up : surge tank with screw on aircraft fittings, pierburg > pre pump and vl turbo fuel pump all brand new and cost 700 dollars, lookin > at around 300 ono for this. > > Fj20 turbo gearbox in very good condition, was rebuilt recently before car > came apart and only used redline oil. can supply crossmember to fit it into > a 1600, as well as tail shaft. With tailshaft and crossmember looking at > offers of around $550 can supply gearbox part numbers etc. > > All 1600 datsun parts i can supply, rust free doors, dash's fuel tanks > gearbox, brakes etc windscreens especially. All must go > All of this is located in perth, only willin to ship the mtx8 or the fuel > supply, the rest is probably too much hassle. > regards chris > > > > > > _________________________________________________________________ > STOP MORE SPAM with the new MSN 8 and get 2 months FREE* > http://join.msn.com/?page=features/junkmail > > --membersozdat------------------------------------------------------- OZDAT Mailing List Please Note:- Send (un)subscribe requests to [EMAIL PROTECTED] Send submissions to [EMAIL PROTECTED] No unauthorised redistribution of this email http://www.ozdat.com/ozdatonline/index.htm http://www.ozdat.com/ozdatonline/listindex.html http://www.mail-archive.com/membersozdat@;datascribe.com.au/ ---------------------------------------------------------------------
