If cam mackinnon is stil on the list can you contact me off group please.l -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] Behalf Of Mark Sent: Wednesday, 19 May 2004 5:05 PM To: [EMAIL PROTECTED] Subject: Re: tie rods
Check the 200sx ones too...I think that is what we used in my 1600....and we had 5 degrees of neg. ----- Original Message ----- From: "Chris Howard" <[EMAIL PROTECTED]> To: <[EMAIL PROTECTED]> Sent: Wednesday, May 19, 2004 3:19 PM Subject: RE: tie rods > Engineers/RTA/Regency or whatever its called in your area will frown upon > any cut and welded steering parts. Stewart wilkins sells longer ones ready > made. > > Cheers, > > Chris Howard > [EMAIL PROTECTED] > http://turbovan.com > > > -----Original Message----- > > From: [EMAIL PROTECTED] > > [mailto:[EMAIL PROTECTED] On Behalf Of > > mark krawczuk > > Sent: Wednesday, 19 May 2004 11:08 AM > > To: [EMAIL PROTECTED] > > Subject: Re: tie rods > > > > hi, i modified mine. i`ve sent u a couple pics of what i`ve done. > > basicall ive cut it in the middle, the bit where the tie > > rods screw onto, > > then got some autoflex steel (cant remember how long, but i > > think i ended > > up with about a 6mm plus/minus 1mm thick wall) > > ), got a hole bored down the middle, drilled some holes in the side . > > > > the bored hole is a snug fit for the adjuster. > > then i put the ends in the auto flex, welded around the > > ends, then plug > > welded inthru the side holes to make sure the adj is securely held > > together. > > > > mark k > > > > > > > > > > ----- Original Message ----- > > From: "Warren Phillip-Clarke" <[EMAIL PROTECTED]> > > To: <[EMAIL PROTECTED]> > > Sent: Wednesday, May 19, 2004 9:59 AM > > Subject: tie rods > > > > > > > > Guys some help please. > > > > I have just wound on some nice negative camber on my rally > > 1600 and now find > > I may need longer tie rods so as to complete a wheel > > alignment giving me > > about 2 deg toe out, it would appear though that my tie rods > > aren't going > > to be long enough. > > > > Is there another model of vehicle with the same diameter and > > thread pitch > > etc with longer rods I can get off the shelf? > > > > Any help greatly appreciated and cost will be a factor at the moment. > > > > Wazza > > > > Warren Phillip-Clarke > > SHRECK Motorsport > > Rallying It's All Good! > > Ph: 0401694264 > > [EMAIL PROTECTED] > > > > > > > --membersozdat------------------------------------------------------- OZDAT Mailing List Please Note:- Send (un)subscribe requests to [EMAIL PROTECTED] Send submissions to [EMAIL PROTECTED] No unauthorised redistribution of this email http://www.ozdat.com/ozdatonline/index.htm http://www.ozdat.com/ozdatonline/listindex.html http://www.mail-archive.com/[EMAIL PROTECTED]/ ---------------------------------------------------------------------
