Some vacuum units are too strong for the relatively low vacuum needed for
oil extraction; vent the vac hose as necessary to reduce/adjust vacuum in
the receiver bucket.
Wilton
----- Original Message -----
From: "Mitch Haley" <m...@voyager.net>
To: "Mercedes Discussion List" <mercedes@okiebenz.com>
Sent: Saturday, May 25, 2013 3:24 PM
Subject: Re: [MBZ] Home Made Topsider
WILTON wrote:
See Archives 26 Aug '05, Homemade/$2 Topsider/Oil Sucker.
Do you mean discharge the oil at bottom of oil receiver can? I would
not; just provide adequate separation between oil discharge tube and vac
tube/hose at top of oil receiver can so that any air in the system slows
down enough to "drop" the oil without entering the vac tube/hose.
It helps if there is a vent of sorts between the shop vac and the
collection vessel so that:
1. the vac gets plenty of air for cooling
2. The vessel doesn't collapse
3. Flow velocity is low enough to prevent oil blowing around in a
hurricane.
Mitch.
_______________________________________
http://www.okiebenz.com
For new and used parts go to www.okiebenz.com
To search list archives http://www.okiebenz.com/archive/
To Unsubscribe or change delivery options go to:
http://mail.okiebenz.com/mailman/listinfo/mercedes_okiebenz.com
_______________________________________
http://www.okiebenz.com
For new and used parts go to www.okiebenz.com
To search list archives http://www.okiebenz.com/archive/
To Unsubscribe or change delivery options go to:
http://mail.okiebenz.com/mailman/listinfo/mercedes_okiebenz.com