Maybe find one on Ebay? Maybe these guys? https://www.appliancepartspros.com/
Have a local appliance repair place that might have it in stock? ------------- Max Charleston SC On Fri, Jul 24, 2020 at 6:33 PM Kaleb Striplin via Mercedes < mercedes@okiebenz.com> wrote: > Well that was a no go, I pulled both the fill and drain hose off it and > tried it, same error. The 3 pulses the pump does discharges water just > fine though. I am now suspecting some sort of control board issue. > Looking at parts diagrams on various sites I see it in the diagram but > the actual part is not listed. Maybe this is what the guy was talking > about as not available anymore. If that is the case, then no choice but > to replace the washer. Unbelievable. > > On 7/24/2020 5:09 PM, Kaleb Striplin via Mercedes wrote: > > So this is the only potential blockage I can find. This assembly mounts > to the side of the washer. It appears to be to serve 2 purposes, draining > and filling goes they it. At the bottom there are 2 ports one is the hose > that comes out from the discharge pump. It flows into the elbow which flows > to the other port at the bottom then out to the sink. The small nipple on > the bottom is the water supply from the fill valve. Water comes in there > and flows thru this unit and emptied out the big middle hole to the > interior of the washer. On the elbow for the drain you can see a channel > that routes around thru the unit and seems to connect with the 4th square > port on the right that connects to nothing. The water supply channel also > seems to connect to this venting system. You can see a section at the top > right of the big hole that looks like it’s full of junk. Nearest I can tell > there should not be any fluids flowing thru here but it looks dirty. I’m > thinking this is all supposed to be air venting. There is no way to take > this apart to clean it out. When the pump tried to run it pushed a small > amount of fluid but I’m wondering if it is supposed to vent air and it had > an air lock? Thoughts? This part is only about $20 so thinking about > replacing it to see. I guess a test I cold do would be to route the hose > from the pump output into a bucket and see if the washer turns on. > > > > > > > > Sent from my iPhone > > > > _______________________________________ > > http://www.okiebenz.com > > > > To search list archives http://www.okiebenz.com/archive/ > > > > To Unsubscribe or change delivery options go to: > > http://mail.okiebenz.com/mailman/listinfo/mercedes_okiebenz.com > > > _______________________________________ > http://www.okiebenz.com > > To search list archives http://www.okiebenz.com/archive/ > > To Unsubscribe or change delivery options go to: > http://mail.okiebenz.com/mailman/listinfo/mercedes_okiebenz.com > > _______________________________________ http://www.okiebenz.com To search list archives http://www.okiebenz.com/archive/ To Unsubscribe or change delivery options go to: http://mail.okiebenz.com/mailman/listinfo/mercedes_okiebenz.com