How do you get the broken one out? Quick swap is ok, gettin wet is ok./Tom
----- Original Message -----
From: "Tom Hargrave" <[EMAIL PROTECTED]>
To: "'Mercedes Discussion List'" <mercedes@okiebenz.com>
Sent: Saturday, December 02, 2006 8:58 AM
Subject: Re: [MBZ] Fw: Too much screwing around
I've broken the outside off mine before & did a quick swap. At the most,
you'll loose a pint or coolant.
Thanks,
Tom Hargrave
www.kegkits.com
256-656-1924
-----Original Message-----
From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]
On Behalf Of [EMAIL PROTECTED]
Sent: Saturday, December 02, 2006 7:33 AM
To: Mercedes Discussion List
Subject: [MBZ] Fw: Too much screwing around
----- Original Message -----
From: <[EMAIL PROTECTED]>
To: "Mercedes Discussion List" <mercedes@okiebenz.com>
Sent: Thursday, November 30, 2006 5:40 PM
Subject: Too much screwing around
Drain, fill drain fill, after de oiling, de calcifying and finishing with
a prestone drive around flush my little screw plug broke on the bottom of
Beher radiator. It is in place but the screw driver part and rubber
piece
just kind of fell off with the last tighting. Plug is in there and
holding coolant but I need to replace.
How would the list suggest I remove the old one and quickly put in a new
one? I thought of screwing two small thin screws in and removing with
pliers. Any thoughts please Car is a 1979 240D
Regards Tom Scordato
Bellefonte PA
_______________________________________
http://www.okiebenz.com
For new parts see official list sponsor: http://www.buymbparts.com/
For used parts email [EMAIL PROTECTED]
To Unsubscribe or change delivery options go to:
http://okiebenz.com/mailman/listinfo/mercedes_okiebenz.com
_______________________________________
http://www.okiebenz.com
For new parts see official list sponsor: http://www.buymbparts.com/
For used parts email [EMAIL PROTECTED]
To Unsubscribe or change delivery options go to:
http://okiebenz.com/mailman/listinfo/mercedes_okiebenz.com
