You must follow the directions with Assembly Lube, as with everything else - some people operate on the principle of "if a little is good a lot is better" - not with assy lube - when applying the assy lube make sure you use a small dab and rub it in good - a blob can stop the flow of oil. And that's when problems start.
As Tom says, oil works as long as you have a good film. Another method that helps is to leave spark plugs / glow plugs out and disconnect the ignition/main power line so the engine will not start - then crank until you see oil pressure on the gauge. Good luck. Larry T (67 MGB, 74 911, 78 240D, 91 300D) www.youroil.net for Oil Analysis and Weber Parts Test Results http://members.rennlist.com/oil PORSCHE POSTERS! youroil.net Weber Carb Info http://members.rennlist.com/webercarbs . ----- Original Message ----- From: "Tom Hargrave" <[EMAIL PROTECTED]> To: "'Mercedes Discussion List'" <mercedes@okiebenz.com> Sent: Thursday, August 09, 2007 7:46 PM Subject: Re: [MBZ] OM603 camshaft installation-success! > Oil is fine as long as you are sure that you have a good coating during > assembly. The risk with oil is that so much may run or drip off that that > you don't have a good oil film in the bearing. But this is not likely if > you > oil & then assemble right away. > > A lot of people like assembly lube because you can verify visually that > there is enough on the part. > > Thanks, > Tom Hargrave > www.kegkits.com > 256-656-1924 > > > -----Original Message----- > From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] > On Behalf Of Zeitgeist > Sent: Thursday, August 09, 2007 6:25 PM > To: Mercedes Discussion List > Subject: Re: [MBZ] OM603 camshaft installation-success! > > I've always used assembly grease. I like this blood-red stuff I got from > NAPA. Sticks around long enough for oil to coat things nicely. > > On 8/9/07, Luther <[EMAIL PROTECTED]> wrote: >> >> Is Mobile 1 good enough? >> > > Casey > __________________________________________ > '87 300TD intercooler/propane/biodiesel > '94 100CSQ Avant > '90 90Q > '89 Bluestar > _______________________________________ > http://www.okiebenz.com > For new parts see official list sponsor: http://www.buymbparts.com/ > For used parts email [EMAIL PROTECTED] > > To Unsubscribe or change delivery options go to: > http://okiebenz.com/mailman/listinfo/mercedes_okiebenz.com > > > _______________________________________ > http://www.okiebenz.com > For new parts see official list sponsor: http://www.buymbparts.com/ > For used parts email [EMAIL PROTECTED] > > To Unsubscribe or change delivery options go to: > http://okiebenz.com/mailman/listinfo/mercedes_okiebenz.com > > > -- > No virus found in this incoming message. > Checked by AVG Free Edition. > Version: 7.5.476 / Virus Database: 269.11.10/943 - Release Date: 8/8/2007 > 5:38 PM > _______________________________________ http://www.okiebenz.com For new parts see official list sponsor: http://www.buymbparts.com/ For used parts email [EMAIL PROTECTED] To Unsubscribe or change delivery options go to: http://okiebenz.com/mailman/listinfo/mercedes_okiebenz.com