On 23/05/12 14:40, Jack Mitchell wrote:
On 23/05/12 11:51, Gary Thomas wrote:
On 2012-05-23 02:44, Jack Mitchell wrote:
On 22/05/12 17:31, Denys Dmytriyenko wrote:
On Tue, May 22, 2012 at 05:03:53PM +0100, Jack Mitchell wrote:
On 22/05/12 16:57, Gary Thomas wrote:
On 2012-05-22 09:48, Jack Mitchell wrote:
Hi,
I am currently trying to boot my beagleboard with a mix of
Poky/Meta-ti/meta-oe, I can build the image without error
however when I start booting the board the kernel gets to
'freeing init memory' and seems to hang, although the beaglebone
light is still flashing and it will still accept keystrokes.
Could anyone shed any light on the situation?
I am on the denzil branch for all three repositories.
I have tried with USB only and USB + AC Adapter.
What image did you use?
core-image-minimal - it does have a few extra programs added via
IMAGE_INSTALL but they are userspace only so shouldn't be affecting
the boot.
Couple suggestions:
1. What's your init system? Since you have meta-oe mixed with poky,
check if
there are any problems with sysvinit or systemd, in case there is
some mix up
or confusion between those two...
2. Check your /etc/inittab for the correct tty used for getty, but
it doesn't
look like it reaches the prompt yet...
I am using Poky defaults so I assume it will be sysvinit... however
I did see systemd being built, what would be the outline procedure
to check that mixing of systems isn't
occurring? None of my reciepes have systemd support, but I assume
something being pulled in from meta-oe does...
My getty is being pushed to ttyO0, is this correct for the beaglebone?
Can you put your images somewhere where I can access them? I can give
you an FTP push site if that helps? I'd like to run through your image
here on my BeagleBone.
BTW, the only way meta-oe could be causing problems would be if you are
using some recipe from it. If you build exactly 'core-image-minimal'
with
no extra packages, does it work for you?
Hi Gary,
I just tried without my addional programs to build a
core-image-minimal and it still halts on the same kernel message.
Something that I forgot to mention the yesterday was that I have a
very high debugging level set, here is my local conf line:
EXTRA_IMAGE_FEATURES = "debug-tweaks tools-debug tools-profile dbg-pkgs"
Which could cause other programs to be brought in?
Regards,
Jack.
Just a quick note that removing meta-oe and just porting over the
specific recipes that I needed fixed my problems. I still don't know
specifically what they were but I am inclined to say they were init
system related as Denys pointed out.
Regards,
--
Jack Mitchell ([email protected])
Embedded Systems Engineer
http://www.embed.me.uk
--
_______________________________________________
meta-ti mailing list
[email protected]
https://lists.yoctoproject.org/listinfo/meta-ti
