Dave Dave, Dave Dave, Dave Dave, I would not even remotely encroach near that arena on that issue at this particular junction.
Having said that, now I know there is a solution in house, I've "messed around" in there before on a 1" bar stock citizen F25 about 10 yrs ago, just wish the memory was better. Thanks J.G. BTW: for the record " it was only once, and I did not inhale " -----Original Message----- From: Dave Coupar [mailto:[EMAIL PROTECTED]] Sent: Friday, June 16, 2000 11:20 AM To: Joe Geraci; 'Smartcam' (E-mail) Subject: RE: [mfg-smartcam] NOT NECESSARILY A SMARTCAM QUESTION Joe, As far as I know: 1. Just a 0 where a 1 should be. 2. All Fanuc 6M's 3. You know of course that it would be illegal to give out Fanuc option parameter numbers..... Dave Coupar [EMAIL PROTECTED] -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]]On Behalf Of Joe Geraci Sent: Friday, June 16, 2000 11:07 AM To: 'Smartcam' (E-mail) Subject: [mfg-smartcam] NOT NECESSARILY A SMARTCAM QUESTION Hi everyone, I have two Fanuc 6M controls, one is "fortified" with macro B capabilities, the other is not. My question is: 1) Is macro B functionality a chip enhancement or just a "1" where a "0" currently is ? 2) If it is a parameter, is the parameter number universal with Fanuc 6M's or dictated by the MTB 3) If it is universal, WHICH ONE(S) IS IT ? Thanks, J.G. ====================================================================== To find out more about this mailing list including how to unsubscribe, send the message "info mfg-smartcam" to [EMAIL PROTECTED] ====================================================================== ====================================================================== To find out more about this mailing list including how to unsubscribe, send the message "info mfg-smartcam" to [EMAIL PROTECTED] ======================================================================
