[mfg-smartcam] Post Issue

[Gary]

I get a blank line in my output code in a tapping cycle. Could someone please help me to eliminate this problem.   @OP_TAP #IF(#CYCLE=0)<#EVAL(#U15=1)>//#U15 USED FOR CHIP BREAK OF DEEP HOLE #IF(#CYCLE=1)<#EVAL(#U15=0)> #EVAL(#V2=(#ZCHK-2.54)) #EVAL(#V3=(#ZDPTH+2.54)) #IFCHG(#WKPLN)< G80 J0> #IFCHG(#WKPLN)< #WKPLN G00 X#XPOS Y#YPOS Z#ZPOS#RESET(#V3)#RESET(#U15)>  < G60 #CYCLE #FDMODE> X#XPOS Y#YPOS< Z#V3 R#V2#EVAL(#V4=#ZPOS-#V2)> W#V4 < J#U15>< F#FMT(#FEED,D3.5)> #EVAL(#U16=1)//USED FOR G80 OUTPUT IN TOOLCHANGE SECTION   @@CYCLE 0,G84       Regards, Gary Marxrieser