Yes I have used checked out Group Blend and it is a wonderful time saver for
adding .01" rads on a profile for our Agie wire machines to prevent
undercuts. Just two clicks to select the profile and Geo Edit, Blend, Group
Blend and you're done! Very slick.
However, I'm still looking for a quicker method of reblending an existing
blend radii...
-----Original Message-----
From: Joe Geraci [mailto:[EMAIL PROTECTED]]
Sent: Thursday, June 15, 2000 10:40 AM
To: 'Michael Senack'; 'Smartcam' (E-mail)
Subject: RE: [mfg-smartcam] Reblending a blend radii
Check out the help section for the group blend function, it
works good.
J.G.
-----Original Message-----
From: Michael Senack [mailto:[EMAIL PROTECTED]]
Sent: Thursday, June 15, 2000 10:13 AM
To: '[EMAIL PROTECTED]'
Subject: [mfg-smartcam] Reblending a blend radii
Is there a .mcl or a quicker method of taking a blend radii
between two
lines on a toolpath or layer profile and reblending that
radii to
another
size?
1) In V4.5 all you had to do was to @SF1,View, Inquire the
blend radii
in
question, and then @SF1, Eidt, Blend and enter a new blend
radii and
voila
it is changed!
2) Now in V11.5 I have to Geo Edit, Trim/Extend the two
lines together,
then
Delete the blend radii, then Blend the two lines.
When you look at it there really is not too much of a speed
reduction in
doing this task between the versions. However, when you have
to do it
more
then once on the same radii then there is no comparison.
V4.5 is
instantaneous as all you have to do is enter a new radii.
Any help here to speed up this process would greatly be
appreciated.
Thanks.
======================================================================
To find out more about this mailing list including how to
unsubscribe,
send the message "info mfg-smartcam" to
[EMAIL PROTECTED]
======================================================================
======================================================================
To find out more about this mailing list including how to unsubscribe,
send the message "info mfg-smartcam" to [EMAIL PROTECTED]
======================================================================
