Yes just as easy as it is to blend a grouped profile you can change it to a different radius. Re-group the profile and put the existing radius size in the "Grp Change Radius" box and the new radius size in the "Inside Radius" box. Group Blend and they all change from the change radius to the inside radius size. COOL
-----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]]On Behalf Of Michael Senack Sent: Thursday, June 15, 2000 10:13 AM To: '[EMAIL PROTECTED]' Subject: [mfg-smartcam] Reblending a blend radii Is there a .mcl or a quicker method of taking a blend radii between two lines on a toolpath or layer profile and reblending that radii to another size? 1) In V4.5 all you had to do was to @SF1,View, Inquire the blend radii in question, and then @SF1, Eidt, Blend and enter a new blend radii and voila it is changed! 2) Now in V11.5 I have to Geo Edit, Trim/Extend the two lines together, then Delete the blend radii, then Blend the two lines. When you look at it there really is not too much of a speed reduction in doing this task between the versions. However, when you have to do it more then once on the same radii then there is no comparison. V4.5 is instantaneous as all you have to do is enter a new radii. Any help here to speed up this process would greatly be appreciated. Thanks. ====================================================================== To find out more about this mailing list including how to unsubscribe, send the message "info mfg-smartcam" to [EMAIL PROTECTED] ====================================================================== ====================================================================== To find out more about this mailing list including how to unsubscribe, send the message "info mfg-smartcam" to [EMAIL PROTECTED] ======================================================================
