|
I posted this question last week, but I don't
think I explained it properly so here goes. Looking at the attachment when I
circ. interp. the 2 bottom parts (horizontal m/c)
the G02 line comes out : G02
I-.2985 which is fine. But when I circ. inter. the top parts the G02 line comes
out: G02 I-.2985 J5.0 which is not fine. If I did the top parts first the G02 on
the bottom parts will be: G02 I-.2985 J-5.0. Each part has its own fixture
offset(workplane). The "J" value seems to be coming from the the top
or bottom parts depending which I do first. My question is why is the
"J" value coming up.
I hope you can understand this.
Thank You
Colin Williams
|
Book1.xls
Description: Binary data
