As far as I know you cannot buy any version other than the last release v11.5.
I believe all SmartCAM licenses for v9.0 and up are backward compatible. This means that while you cannot run v11 on a v10 key, you can run v10 on a v11 key. This was done to allow you to run a newer version simultaneously with an older version. (To do this you need to have separate copies of your SmartCAM.ini file in the system folders located within separate SmartCAM folders.) Is anyone in the group currently doing this and can verify If I'm correct? If this is correct and you have a V10 CD, you could purchase a license of Advanced Production Milling v11.5 and use it's key to operate v10. If you do not have a v10 CD then your stuck with v11.5. ============================================= Fred Lauzus, CAM Programming Coordinator High Steel Structures, Incorporated mailto:[EMAIL PROTECTED] http://www.highsteel.com ============================================= -----Original Message----- From: Robert Lee [mailto:[EMAIL PROTECTED]] Sent: Tuesday, October 10, 2000 10:47 AM To: SMART CAM USERGROUP Subject: [mfg-smartcam] Is it still possible to buy a seat of advanced 3-D MILL VER. 10.0 THANK YOU ROBERT LEE [EMAIL PROTECTED] ====================================================================== To find out more about this mailing list including how to unsubscribe, send the message "info mfg-smartcam" to [EMAIL PROTECTED] ======================================================================
