HI, Im new on this e-mail list. I had sent two previous messages regarding this problem I have but receive no answer I think I sent them to a wrong adress. Hope u get this one!
Im using Advanced Wire EDM v 11.5 with an old JAPAX WireEDM. While cutting some small radius Im getting an undercut. The tech. support told me that this could be caused by a number crunching when the WIRE EDM transfer the code (which is in English units) to metric. I want to try more digits at the right side of the decimal point (5 or 6 at least) 'cuse smart cam only uses 4, but dont know how to do it. Can someone of u guys help me out with this?? thanks a lot in advance!! Saul (787) 890-4764 (Puerto Rico) ====================================================================== To find out more about this mailing list including how to unsubscribe, send the message "info mfg-smartcam" to [EMAIL PROTECTED] ======================================================================
