why not just switch your .smf file to output tool centerline, and then your code could care less if the radius is smaller than the tool radius. This makes the whole thing automatic. Jon
----- Original Message ----- From: <[EMAIL PROTECTED]> To: <[EMAIL PROTECTED]> Sent: Wednesday, November 22, 2000 9:53 AM Subject: [mfg-smartcam] Multiple Radius edit > I have an imported file with 140+ arbitrary pockets each with .25 and .06 corner > radius. Is there a way to do a "mass" change of the radius? I guess what i'm > shooting for is that i need to do wall offsets to create roughing profiles and > when using wall offset pending upon offset amount the radius gets smaller > creating a tool dia/offset problem. Thanks, Rick (FF) > > ====================================================================== > To find out more about this mailing list including how to unsubscribe, > send the message "info mfg-smartcam" to [EMAIL PROTECTED] > ====================================================================== > > ====================================================================== To find out more about this mailing list including how to unsubscribe, send the message "info mfg-smartcam" to [EMAIL PROTECTED] ======================================================================
