The server code is an intermediate number that is based on the serial number of the hard drive. I think they do that to throw you off as it is not connected to any one piece of hardware, nor is it in a .ini file that can be changed. The serial number is generated anytime you format the hard drive.
Ron > -----Original Message----- > From: [EMAIL PROTECTED] > [mailto:[EMAIL PROTECTED]]On Behalf Of Dave Hayden > Sent: Thursday, July 20, 2000 11:37 AM > To: SmartCam Tech (E-mail) > Subject: [mfg-smartcam] RE: License Keys > > > I just spent 15 minutes on the phone trying to get a hold of > someone at > SDRC regarding license keys and all I got was useless voice > mail menus. > What I should have done in the first place is to write this > group where the > experts are willing to help and not hide behind a recording. > > Anyway, I recently replaced a failing drive with a new one. > I copied the > contents of the original drive onto the new drive and > immediately submitted > the license key request for the existing Advanced 3D along with a new > request for Production Turning. > > The two requests had different server codes. I received a > license key for > the new request (turning) but was told that the server code for the > previously installed product I copied over (amill) was invalid. > > Is the license key utility, which previously existed on the original > drive, just looking at a .ini or .dat file and retrieving the > old server > code rather than getting a new server code from the new > drive? If so, How > do I force it to retrieve a new server code? Or, can I just > type in the > server code from the license key that did work? > > Any comments, thoughts or suggestions will be greatly appreciated. > > Also, has anyone out there mastered the settings in the IGES > converter or > is there a list of what effect the various settings have on the output > (.pm4) file? > > David S. Hayden > Elliott Turbomachinery > Jeannette, PA > > > ====================================================================== > To find out more about this mailing list including how to unsubscribe, > send the message "info mfg-smartcam" to [EMAIL PROTECTED] > ====================================================================== > > ====================================================================== To find out more about this mailing list including how to unsubscribe, send the message "info mfg-smartcam" to [EMAIL PROTECTED] ======================================================================
