John, I don't know where this diagnostics gremlin came from, but today I re-ran setup and it went back into hiding. I was wondering if I had inadvertantly triggered this event? I have searched but can't find a way to make it run, pretty weird. FWIW, it never did anything bad at all, it was just a bit of a nag to have to close the box to start Smartcam. Thanks for your assistance, Michael
John Gent wrote: > Hey Mike, > > There should be some messages past the dll stuff that should tell you why. > Usually not finding some file or a corrupt file. > > Mike Gailey wrote: > > > I have a diagnostics box running on startup. Don't know why but this > > started today, I honestly do not know how this got triggered to run. Now > > how do I disable it? > > Anyone... > > Thanks, > > Michael > > > > -- > > Visit us at http://www.microsystemsgeorgia.com/toc.htm for > > Smartcam and Rhino information. > > > > ====================================================================== > > To find out more about this mailing list including how to unsubscribe, > > send the message "info mfg-smartcam" to [EMAIL PROTECTED] > > ====================================================================== > > -- > John Gent > Structural Dynamics Research Corporation > CAM-QA Eugene, Oregon > > The secret of life is nothing at all. - Gretchen Peters > > ====================================================================== > To find out more about this mailing list including how to unsubscribe, > send the message "info mfg-smartcam" to [EMAIL PROTECTED] > ====================================================================== -- Visit us at http://www.microsystemsgeorgia.com/toc.htm Smartcam Support Repository and Rhino Modeling for CNC Milling ====================================================================== To find out more about this mailing list including how to unsubscribe, send the message "info mfg-smartcam" to [EMAIL PROTECTED] ======================================================================
