RE: [mfg-smartcam] Workplanes

[Nix, Dan]

Title: Untitled Stationery

I define my workplanes as 1, 2, 3,...on up to 50 on our Mazak Ultra 650 and then have the following in my template file.

 

G54.1 P#WKPLN

-----Original Message-----
From: Williams, Colin [mailto:[EMAIL PROTECTED]]
Sent: Wednesday, January 17, 2001 11:59 AM
To: Smartcam Forum (E-mail)
Subject: [mfg-smartcam] Workplanes

In the workplane - define plane, I need to use extended fixture offsets for a Fanuc control, but it will only allow me to define up to G54.1 P9, anything beyond that will ask if I need to replace it.

 

I would like to define from G54.1 P10 thru to G54.1 P24.

 

Is there a way to do this?

 

Thank you

 

Colin Williams



WABTEC CORPORATION CONFIDENTIALITY NOTE
The content contained in this e-mail transmission is legally privileged and confidential information intended only for the use of the individual or entity named herein. If the reader of this transmission is not the intended recipient, you are hereby notified that any dissemination, distribution, or copying of this transmission is strictly prohibited.