Too bad you don't have a Fadal, they have a canned cycle to do that for you.
----- Original Message ----- From: "Jim Schellpfeffer" <[EMAIL PROTECTED]> To: <[EMAIL PROTECTED]> Sent: Monday, February 05, 2001 7:55 AM Subject: [mfg-smartcam] Engraving Macro > I need to engrave some small flat pieces with serial numbers 001 thru 1000, > not wanting to re-invent the wheel I figured someone out there would have a > macro to do the job. I could customize it for my needs but if someone would > have the "frame work" to start with I would greatly appreciate it! > > Jim S. > > Jim Schellpfeffer > Machine Dev. & Maint. Group > [EMAIL PROTECTED] > (630)840-4029 > ====================================================================== > To find out more about this mailing list including how to unsubscribe, > send the message "info mfg-smartcam" to [EMAIL PROTECTED] > ====================================================================== > > ====================================================================== To find out more about this mailing list including how to unsubscribe, send the message "info mfg-smartcam" to [EMAIL PROTECTED] ======================================================================
