I think I need to clarify what I am doing:
I will be cutting these parts out of a single sheet so I was looking for a
macro to index the X,Y location and the serial number 001 to 1000 in the
"TEXT" window. I then will cut the parts out after the engraving is done.
Thanks
Jim S.
> Try this loop to get you started.
>
>
> =============================================
> Fred Lauzus, CAM Programming Coordinator
> High Steel Structures, Incorporated
> mailto:[EMAIL PROTECTED] http://www.highsteel.com
> =============================================
>
>
>
>
> -----Original Message-----
> From: Jim Schellpfeffer [mailto:[EMAIL PROTECTED]]
> Sent: Monday, February 05, 2001 10:55 AM
> To: [EMAIL PROTECTED]
> Subject: [mfg-smartcam] Engraving Macro
>
>
> I need to engrave some small flat pieces with serial numbers 001 thru 1000,
> not wanting to re-invent the wheel I figured someone out there would have a
> macro to do the job. I could customize it for my needs but if someone would
> have the "frame work" to start with I would greatly appreciate it!
>
> Jim S.
>
> Jim Schellpfeffer
> Machine Dev. & Maint. Group
> [EMAIL PROTECTED]
> (630)840-4029
> ======================================================================
> To find out more about this mailing list including how to unsubscribe,
> send the message "info mfg-smartcam" to [EMAIL PROTECTED]
> ======================================================================
>
>
Jim Schellpfeffer
Machine Dev. & Maint. Group
[EMAIL PROTECTED]
(630)840-4029
======================================================================
To find out more about this mailing list including how to unsubscribe,
send the message "info mfg-smartcam" to [EMAIL PROTECTED]
======================================================================
