I had the same problem when we first got our mill. My coed generator coded the S code and the X,Y moves on the same line I just moved the spindle code (S1000) for instanced to the previous block (in my template file) by itself and the spindle comes up to speed before the machine moves.
----- Original Message ----- From: Joel Harris <[EMAIL PROTECTED]> To: Bob Anderson <[EMAIL PROTECTED]> Cc: <[EMAIL PROTECTED]> Sent: Friday, June 01, 2001 5:22 PM Subject: Re: [mfg-smartcam] spindle speed delay > On Yasnac controls, the machine will not go to the next block until, > the speed is within 10% of programed rate. > Tapping cycles have to wait for the whole amount. > Doesn't yours do that? > > > > Bob Anderson wrote: > > > I would like to add some logic to my template that will insert a G4 > > dwell only above a certain rpm to allow the spindle on a large machine > > to get up to full rpm before it starts cutting. Maybe even a specified > > dwell for a specified range- say 7000-9000 = G4 X3. (3 second delay) and > > 9001-12000 = G4 X5 (5second delay). > > Thanks > > Bob Anderson > > Camtron > > -- > Carr Tool Co. Inc. Londonderry NH 03053 > http://www.carrtoolcoinc.com > > > ====================================================================== > To find out more about this mailing list including how to unsubscribe, > send the message "info mfg-smartcam" to [EMAIL PROTECTED] > ====================================================================== > ====================================================================== To find out more about this mailing list including how to unsubscribe, send the message "info mfg-smartcam" to [EMAIL PROTECTED] ======================================================================
