On Yasnac controls, the machine will not go to the next block until, the speed is within 10% of programed rate. Tapping cycles have to wait for the whole amount. Doesn't yours do that?
Bob Anderson wrote: > I would like to add some logic to my template that will insert a G4 > dwell only above a certain rpm to allow the spindle on a large machine > to get up to full rpm before it starts cutting. Maybe even a specified > dwell for a specified range- say 7000-9000 = G4 X3. (3 second delay) and > 9001-12000 = G4 X5 (5second delay). > Thanks > Bob Anderson > Camtron -- Carr Tool Co. Inc. Londonderry NH 03053 http://www.carrtoolcoinc.com ====================================================================== To find out more about this mailing list including how to unsubscribe, send the message "info mfg-smartcam" to [EMAIL PROTECTED] ======================================================================
