I have another question. We just installed pturn v11.0 on another computer, I noticed when I fill in "z" & d" by itself it goes through all the fields and nothing shows up. However when I highlight "start point" & end point I get my geometry. I remember there was a tech note about this.
Thank you Colin Williams WABTEC CORPORATION CONFIDENTIALITY NOTE The content contained in this e-mail transmission is legally privileged and confidential information intended only for the use of the individual or entity named herein. If the reader of this transmission is not the intended recipient, you are hereby notified that any dissemination, distribution, or copying of this transmission is strictly prohibited. ====================================================================== To find out more about this mailing list including how to unsubscribe, send the message "info mfg-smartcam" to [EMAIL PROTECTED] ======================================================================
