Thank you.
-----Original Message-----
From: Jason Otto [mailto:[EMAIL PROTECTED]]
Sent: Wednesday, June 27, 2001 9:15 AM
To: Williams, Colin
Cc: 'Lauzus, Frederick'; Smartcam Forum (E-mail)
Subject: Re: [mfg-smartcam] start point
Colin-
I think this is what you are after:
===============================
Topic: Can't Create/ Geometry/ Line with Step using keyboard input in the
dialog box
SDRC/CAMAX
TECHNICAL SUPPORT
GROUP
Technote
170
Date:
12/17/97
Author:
JM
Product
Production Turning
Advanced Turning
Version
v11.0
Problem:
When inserting with a turning tool, cannot input start and end coordinates
in the Create/ Geometry/ Line
dialog box using the keyboard.
Solution:
This problem can be corrected by down loading the appropriate patch for your
application from
http://www.I-deas.com/nav/support-training/product-updates/patches/patches.h
tml
====================================
Jason Otto
SDRC ASC - Minneapolis, MN USA
"Williams, Colin" wrote:
> I have another question.
>
> We just installed pturn v11.0 on another computer, I noticed when I fill
in
> "z" & d" by itself it goes through all the fields and nothing shows up.
> However when I highlight "start point" & end point I get my geometry. I
> remember there was a tech note about this.
>
> Thank you
>
> Colin Williams
>
> WABTEC CORPORATION CONFIDENTIALITY NOTE
> The content contained in this e-mail transmission is legally privileged
and confidential information intended only for the use of the individual or
entity named herein. If the reader of this transmission is not the intended
recipient, you are hereby notified that any dissemination, distribution, or
copying of this transmission is strictly prohibited.
> ======================================================================
> To find out more about this mailing list including how to unsubscribe,
> send the message "info mfg-smartcam" to [EMAIL PROTECTED]
> ======================================================================
WABTEC CORPORATION CONFIDENTIALITY NOTE
The content contained in this e-mail transmission is legally privileged and
confidential information intended only for the use of the individual or entity named
herein. If the reader of this transmission is not the intended recipient, you are
hereby notified that any dissemination, distribution, or copying of this transmission
is strictly prohibited.
======================================================================
To find out more about this mailing list including how to unsubscribe,
send the message "info mfg-smartcam" to [EMAIL PROTECTED]
======================================================================
