Dave-
Aturn does work with C axis output. It should give you correct rotary motion
without any trouble. I can't recall off the top of my head, but some of the sample
code generators are set up for this sort of output.
Best regards,
Jason
[EMAIL PROTECTED] wrote:
> Jason,
> I'm revisiting this issue because I now have Aturn V11.5 and a Vertical Turret
> Lathe with live tooling and was wondering if the same info about C axis applies.
> I'm trying to program a simple B.C..
>
> Thanks, Dave
>
> Jason Otto <[EMAIL PROTECTED]> on 02/14/2001 11:54:29 PM
>
> To: Dave Coupar <[EMAIL PROTECTED]>
> cc: David Vandervort/USA/Praxair@Praxair, [EMAIL PROTECTED]
>
> Subject: Re: [mfg-smartcam] Tpindx
>
> Sorry guys,
>
> SmartCAM does not support C axis rotary motion in the milling applications. A
> and B axes will work fine, but C does not get you correct output. It will
> always output X and Y motion in order to get from point 1 to point 2 in the XY
> plane, rather than C axis rotation. We would have liked to get this added to
> the software, but it just didn't pan out.
>
> Best of luck,
> Jason Otto
> SDRC ASC - Minneapolis, MN USA
>
> Dave Coupar wrote:
>
> > David,
> >
> > I tried to modify a post to output C rotations, but was unsuccessful, too,
> > even with the workplanes rotated about z-axis as they should be. Might be
> > time to call for expert advice.
> >
> > Oh Greg O, wherefore art thou, Oh Greg O?
> >
> > Dave
> >
> > ----- Original Message -----
> > From: <[EMAIL PROTECTED]>
> > To: <[EMAIL PROTECTED]>
> > Sent: Tuesday, February 13, 2001 4:12 PM
> > Subject: [mfg-smartcam] Tpindx
> >
> > >
> > > I am using Amill V11.5 and am trying to create geometry on a VMC with a
> > 4th axis
> > > ("C") that will output a value to the Tpindx
> > > section for C axis.
> > >
> > > I start by creating a hole in the XY plane and then rotating (copying)
> > around
> > > the Z axis with suppress plane off. Smartcam
> > > accesses the Tpindx section each time but my holes have no angular value,
> > just
> > > XY coordinates. I do this same procedure
> > > on a HBM on the "B" axis (around Y )and it works. Help.
> > >
> > > Thanks, Dave
> > >
> > >
> > > ======================================================================
> > > To find out more about this mailing list including how to unsubscribe,
> > > send the message "info mfg-smartcam" to [EMAIL PROTECTED]
> > > ======================================================================
> > >
> >
> > ======================================================================
> > To find out more about this mailing list including how to unsubscribe,
> > send the message "info mfg-smartcam" to [EMAIL PROTECTED]
> > ======================================================================
======================================================================
To find out more about this mailing list including how to unsubscribe,
send the message "info mfg-smartcam" to [EMAIL PROTECTED]
======================================================================
