|
I use Freeform, but this applies to all of the
milling modules. When I use Create-Machine Event-Feed Change to modify a
feed rate it works just fine, however from that point in the model forward, it
keeps that feed rate. On a part I was just surfacing, I want the
first cut to go slower since it is taking a full bite, but then each step over
is only .005 so I want that to go faster. What I did, was slow my feed in
the jos to 40ipm and after the first element, bump it to F70.0 ipm in the feed
change. Then when I pull out of that surface, and start another one with
the same tool-step, I would think it would update upon the down feed and profile
start, however it doesn't. It keeps the 70ipm rating and runs with
it.
So, is this a .tmp problem? or a .smf problem, or
just one of those things.
I am sending my .tmp file along so you can see what
I am doing in there too.
Thanks for any help.
Jon Baker
|
Fadal.tmp
Description: Binary data
