Hi John, Here are the settings I use for the Haas.......
Setting #11 Baud Rate ---19200 Setting #12 Parity ---Even Setting #13 Stop bits -- 2 Setting #14 Synch. -- Xon/ Xoff Setting #37 Data Bits---7 Setting #24 Leader to Punch --none Setting #25 EOB Pattern --- CR LF These are the settings at the machine....just use these in Communicate and create a new Machine file The cable I believe is just a null modem type, but check your manual it has the specs. DNC works fine 90% of the time, sometimes it stalls. I'm not sure why this happens. regards Scott Stephens ----- Original Message ----- From: "John Morris" <[EMAIL PROTECTED]> To: "Smartcam User Group (E-mail)" <[EMAIL PROTECTED]> Sent: Thursday, April 11, 2002 10:03 AM Subject: [mfg-smartcam] Slightly OT - Communicate and Haas - DNC > I was hoping someone would share the ".SC" file used with the original > Communicate software that came with Smartcam to send files to my Haas. I > use it on every other machine but since the Haas came with a floppy drive > (and was a bit further away) I have just used the floppy up to this point. > Now I'm planning to place my PC close enough to the Haas which would make > running a cable more realistic and will need to set up the parameters to > communicate and was looking to save some time working them out (though the > book has the specifics for machine, I'm concerned about trouble with the > character strings in the Comm. settings). > > Second question, has anyone used the Communicate software to run DNC to any > machine? I've never tried with any of the other machines (because they do > not have the DNC option) but since I have used the DNC option using the > Floppy on the Haas (mill) it makes me want to try running DNC over the > cable. Any comments on this? > > John Morris > > > > ====================================================================== > To find out more about this mailing list including how to unsubscribe, > send the message "info mfg-smartcam" to [EMAIL PROTECTED] > ====================================================================== ====================================================================== To find out more about this mailing list including how to unsubscribe, send the message "info mfg-smartcam" to [EMAIL PROTECTED] ======================================================================
