The problem is inserting a depth on the tapping cycle.For example I would like to tap a hole with a 1/4-20 tap. On the tool page I will insert .25 for tool Dia. 20 for the TPI. Then on the Operation page I insert .05 for the IPR David Leban DFL TOOL INC
David,
Why are you changing the IPR when all you have to do is set the RPM to what ever RPM you run your machines at.
the IPR should pull in the JOS(pitch) from the tool portion of the tool.
This may be your problem.
Hope this helps.
Kevin Clark
Programmer
Abbott Workholding Inc.
======================================================================
To find out more about this mailing list including how to unsubscribe,
send the message "info mfg-smartcam" to [EMAIL PROTECTED]
======================================================================
