Try changing the L0.4 format for R to P0.4 #FXD X#XPASS Z#ZPASS P#FMT(#V11,F0.4) R#FMT(#XOV,P0.4) Q#FMT(#V2,F0.4) F#FTHRD
============================================= Fred Lauzus, CAM Programming Coordinator High Steel Structures, Incorporated mailto:[EMAIL PROTECTED] <mailto:[EMAIL PROTECTED]> http://www.highsteel.com <http://www.highsteel.com/> ============================================= -----Original Message----- From: Williams, Colin [mailto:[EMAIL PROTECTED]] Sent: Thursday, October 10, 2002 2:01 PM To: Smartcam Forum (E-mail) Subject: [mfg-smartcam] Threading N93 G76 P010060 Q0030 R0030 <<<<<<<<<<<<<<needs to be R.0030 N94 G76 X0.306 Z-0.349 P0510 R0 Q0100 F0.059 What do I need to change to get the "R" value to be a decimal. Here is my tmp section: @FXD1 #FXD P#FMT(#U5,L2.0)#FMT(#V5,F2.0)#FMT(#INDXA,F2.0)#EXLN Q#FMT(#V14,F0.4) R#FMT(#V14,F0.4) #FXD X#XPASS Z#ZPASS P#FMT(#V11,F0.4) R#FMT(#XOV,L0.4) Q#FMT(#V2,F0.4) F#FTHRD Thank you Colin WABTEC CORPORATION CONFIDENTIALITY NOTE The content contained in this e-mail transmission is legally privileged and confidential information intended only for the use of the individual or entity named herein. If the reader of this transmission is not the intended recipient, you are hereby notified that any dissemination, distribution, or copying of this transmission is strictly prohibited. ====================================================================== To find out more about this mailing list including how to unsubscribe, send the message "info mfg-smartcam" to [EMAIL PROTECTED] ======================================================================
